The Boot washer at ground level, manufactured in Switzerland, is a professional cleaning system made of stainless steel, which is ideal for tough, daily use in fire stations and police stations, butcher's shops or in agriculture due to its robust construction. The boot washing machine is designed for permanent installation on the floor, is available for 1 - 4 persons and is delivered ready for connection. It is also suitable for installation on an existing grating provided by the customer. The boot cleaning system is equipped with a high-quality water-bearing hand brush and sole and sole edge brushes with spray nozzles. The low side brushes make this boot cleaner also suitable for cleaning ankle-high work shoes. A grab rail attached to the system ensures a secure hold during boot cleaning.
The Boot Washer at ground level impresses with the following features:
- Grate with integrated brushes and water nozzles.
- Due to the deep brush arrangement also ideal for cleaning work shoes (ankle-high).
- 1-4 pieces hand brushes with hand pressure valve, hose approx. 1,3m with quick coupling.
- One separate valve each for water nozzles in the grate and for hand brush.
- With large collecting pan for draining the used water.
- Water consumption at 4 bar approx. 18 lt./min.
- Pressure 4 - 8 bar.
- Made of high-quality stainless steel.
- No power consumption!
- Made in Switzerland!
Image: Boot washer at ground level (made in Switzerland) for boots and ankle-high work shoes.
For boot cleaning, the boot is first placed on the sole cleaning brush. The 60 fine nozzles of the sole and side brushes are activated by operating the water valve attached to the retaining bracket. By rubbing and turning the boot in the brushes, all dirt is rubbed off the soles and sole edges. Even the most stubborn dirt is quickly removed by the supply of fresh water.
The boot shafts and the upper side can then be easily cleaned with the water-bearing hand brush. Water is supplied to the hard nylon bristles via the manual valve. This combination removes all dirt from the boot shafts in no time. In addition, other equipment can be easily cleaned with the hand wash brush.
The dirt rubbed off by the boots is washed away by the water and flows into the water drain via the integrated drain trough. The distribution of moisture and dirt in the cleaning area of your company can be clearly prevented with this boot washing system.
The water connection must correspond to the regulations of the responsible waterworks and must be carried out by an authorised specialist company. When connecting to the drinking water system, a customer-approved pipe aerator/pipe separator is recommended (not included in delivery).
Casing: stainless sheet steel 1.4301
Grate: Stainless steel
Dimensions: (Version: 1st combination with 1 manual brush)
591 mm x 705 mm x 280 mm (width x depth x height)
Dimensions: (Version: 2nd combination with 2 manual brushes)
1200 mm x 705 mm x 280 mm (width x depth x height)
Dimensions: (Version: 3rd combination with 3 manual brushes)
1804 mm x 705 mm x 280 mm (width x depth x height)
Dimensions: (Version: 4th combination with 4 manual brushes)
2408 mm x 705 mm x 280 mm (width x depth x height)
Water inflow: G 3/4"
Water outflow: Water is directed underneath using a G 1 ½" internal screw thread
It should be installed on a pre-existing grating.
Electrical supply: No power required
Warranty: 2 years