The Boot washer combined with steel grating is a stationary boot washer, which is installed in a standard grating. Can be installed at ground level or partially immersed in the floor, or as a pit cover. For use in fire stations, military accommodation, or for commercial and agricultural purposes.
Galvanised installation frame with coarse brush for the soles
2 lateral brush strips for optimal cleaning of the footwear up to the ankle area
It can also be used to clean work shoes
Galvanised grid on hinges
Galvanised grating covering the brushes (allowing complete accessability)
Dimension angle frame made of 35x5 galvanised angle iron (see options)
Water valve (with automatic timer) controlled by a foot pedal with spray nozzles fitted on the sides
Supplied with water-bearing hand brush and stainless steel support handrail
No power necessary!
The Boot washer combined with steel grating can be installed at ground level (completely immersed) or partially sunk.
Image: Boot washer combined with steel grating with hand held brushes with water flowing through for cleaning the boot legs.
This means that because this boot washer is integrated in standard grating, it can be installed in various ways, for example directly into manhole/pit covers. The Boot washer combined with steel grating offers high flexibility when it comes to its place of installation. Other grating sizes are available by
request.
A firmly mounted
stainless steel support handrail ensures a secure and stable footing during use. There is no risk of accidents with the completely immersed model, because when the boot washer is covered, it is not possible to trip over it.
The Boot washer combined with steel grating uses a hard brush for the soles and two softer brushes on the sides for efficient cleaning of the footwear. There is an automatic water stopping valve fitted to the front of the basin, which is activated by using the foot. When the user presses on the button with for example the tip of his shoe/boot, water will flow from the spraying jet nozzles for 15 seconds.
At the front of the basin, an automatic water valve is attached, which is controlled with the tip of the foot. The water reaches the brushes and footwear from all sides through small spray nozzles. After this, the footwear is scrubbed from all angles to get rid of every last bit of dirt. The foot valve has an adjustable flow rate of 7, 15 or 30 seconds, so water consumption can be reduced where possible.
We offer the following optional components: Single dimension angle frame made of 35x5 angle iron in galvanised version and lateral concrete anchors approx. 50 mm long for mounting on the raw concrete. For transport, the support handrail at the head end is removed, enabling space-saving and secure delivery.
The water connection must comply with the regulations of the responsible waterworks. The European standard DIN EN 1717 is the guideline here, supplemented by national standards. The drinking water installation must be carried out exclusively by an authorised specialist company. When connecting to the drinking water system, an approved system separator / pipe separator must be considered (not included in the delivery).
