Description
Sole-shaft-cleaner for boots removes dirt and mud from boots quickly and reliably.
This boot cleaner replaces the time-consuming and unpleasant manual cleaning of work shoes. It can also increase safety in smaller businesses by eliminating inefficient and unsafe cleaning with tubs and washbasins.
The sole and shaft cleaner for boots is recommended for smaller businesses of all kinds for the following reasons:
- Safe and comfortable to use.
- Efficient and easy cleaning of heavily soiled boots
- Due to the lack of electricity and the low water consumption, this boot washer is very economical and ecological
- Low time loss during boot cleaning in comparison to classical methods
Image: Sole-shaft-cleaner for boots with high brush strips for optimum boot cleaning.
All in all, the boot washer sole-shaft-cleaner for boots is equipped with 5 high-quality plastic brushes. Each of these brushes has 10 nozzles from which a powerful water jet sprays. The strong water flow washes away coarse dirt and in combination with the rubbing of the shoes on the hard bristles of the bottom and side brushes leads to perfectly clean boots. The nozzles of the side brushes can be deactivated via a regulator, which leads to a significant increase in the water pressure from the floor brush and also allows very stubborn impurities to be flushed away.
In contrast to many other boot washers, the intensive water spray nozzles clean even boot shafts thoroughly up to the very top. With the separately available hand brush, even hard-to-reach areas and other equipment such as aprons or boxes can be cleaned quickly and thoroughly (see accessories below).
The sole-shaft-cleaner for boots is highly recommended primarily for ecological and economic reasons:
- Ecological as no electricity and little water is consumed
- Economical because no electricity is needed and employees save time
- In contrast to electric / motorized solutions, this boot washer is very inexpensive
This boot cleaner is made of powder-coated steel as standard. The stainless steel version, which can be selected under option, is suitable for very humid areas of application or contact with acid soiling. If you are looking for a functionally identical device that can also be used for work shoes with a low upper, we recommend the sole-shaft-cleaner for working shoes.
Technical data
Case: powder-coated steel / stainless steel (option)
Dimensions:
With handle retracted (storage/transport): 40 x 40 x 50 cm (width x depth x height)
With handle extended (active use): 40 x 40 x 87 cm (width x depth x height)
Water inflow:
Water outflow: free downwards
Operating temperature: 0° C - 50° C
Max. Water temperature: 60° C
Water pressure: max. 4 bar
Electrical supply: not necessary
Weight:
Warranty: 1 year
|